Full Image Backup fails:Could not read MBR

[Fabian_Muller]

I can confirm, it is really not there.

However, in regard to this thread

Missleading error message: "Could not read MBR"

After activating the image backup for a client and starting a full image backup through the web interface, I get the following error message in the client protocol: Could not read MBR Cannot retrieve master boot record (MBR) for the disk from the client. After digging around a bit I noticed that the volume to image was not specified. After entering volume C, the image backup started as expected. I would suggest to adjust the error message for this case. Server: UrBackup 2.4.11 Client: UrBa…

I want to point out, that C is set as drive to create an image from: